fereib.blogg.se

1. How to open hood with broken release cable mk 4 mondeo how to#
2. How to open hood with broken release cable mk 4 mondeo install#

If you don't like the cut away section underneath the Ford badge, a nifty £10 should see a replacement from the local scrappy.

How to open hood with broken release cable mk 4 mondeo install#

FORD FOCUS MK2 BONNET LATCH CONVERSION INSTALL GUIDE (MK4 MONDEO KIT). 4:37: by John Lee Hooker on Boogie Chillen & Other Favorites (Digitally.

How to open hood with broken release cable mk 4 mondeo how to#

Cassette Duplication Diy How To Open Hood With Broken Release Cable Mk 4 Mondeo Olarila High Sierra Atlauncher The Biggest Modpack Onetouch Diabetes Management Software Ludo Putovanje Igra. Allow 45 minutes to complete removal, and another 45 to rinse, oil and grease and replace the lock. ford focus bonnet lock replacement opening mechanism follow on vid. How To Open Hood With Broken Release Cable Mk 4 Mondeo Olarila High Sierra. A staightforward and simple job requiring only a drill and a spot of ingenuity. Pull up ón the hood tó open it, stiIl applying tension tó the wire.

Hey presto, saving a couple of hundred snots from your friendly thieving Ford franchise. Step 4 Pull the wire in the opposite direction of the hook while depressing the hood. Or you can rinse out the existing lock and oil well then vaseline or use a water proof grease and replace using conventional screws. You may want to reduce future hassle and leave it at this, but remember to carry a suitable screwdriver in the car. Ok, im in, removed 2 x 10 mm bolts from back side of latch mechanism and it acts as a cover, flipped the release switch from there, removed latch and nothing wrong with it, operates as it should be moving the arm so cleaned it all up with heaps of wd40 just in case.however, theres a spring that fell off the cable operating arm. You can then use a long screw driver to release the lock as with the key (first left, then to the right). Then work the lock out by the bottom of the grill then remove the plastic sleeve from inside the mechanism. These may need drilling out if not been replaced by conventional screw heads. Symptoms: Cable has gone loose, frayed, bonnet not releasing, cable snapped, broken, bonet stuck shut, wont release, wont open.

If you've tried the obvious - key twisting, bonnet sitting, cursing - then cut through the plastic by the key hole so you can see through to the two screws holding the lock mechanism in place.